Kia stinger service manual

Kia Stinger: Brake System

Using a non-genuine DOT3/DOT4 brake fluid can cause corrosion and decrease the life of the system.

Avoid contaminating the brake fluid by keeping it away from dirt or other foreign matters.

Do not spill brake fluid on the vehicle as it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.

The reservoir on the master cylinder must be at the MAX (upper) level mark at the start of bleeding procedure and checked after bleeding each brake caliper.

Make sure that the brake fluid in the reservoir is filled upto the MAX (upper) level line.

Have someone slowly pump the brake pedal several times, and then apply pressure.

Loosen the rear right-hand side brake bleed screw (A) to allow air to escape from the system. Then tighten the bleed screw securely.

Let the inner (A) air bleeding and then let the outer (B) air when the procedure of air bleeding brembo brake air.

Repeat the procedure for all wheels in the sequence shown below until air bubbles no longer appear in the fluid.

Refill the master cylinder reservoir upto the MAX (upper) level line.

Do not reuse the old brake fluid. Use only new clean brake fluid.

ESP Bleeding of Brake System

Follow this procedure to ensure adequate bleeding of air and filling of the ESP unit, brake lines and master cylinder with brake fluid.

Remove the reservoir cap and fill the brake reservoir with brake fluid.

If there is any brake fluid on any painted surface, wash it off immediately.

When pressure bleeding, do not depress the brake pedal.

Recommended fluid: DOT3 or DOT4

Connect a clear plastic tube to the wheel cylinder bleeder plug and insert the other end of the tube into a half filled clear plastic bottle.

Connect the KDS to the data link connector located underneath the dash panel.

Select and operate according to the instructions on the KDS screen.

Comply with the maximum operating time of the ESP motor on the KDS to prevent the motor pump from burning.

Select HCU air bleeding mode.

Pump the brake pedal several times, and then loosen the bleeder screw until fluid starts to run out without bubbles. Then close the bleeder screw (A).

Let the inner (A) air bleeding and then let the outer (B) air when the procedure of air bleeding brembo brake air.

Repeat step 5 in the order shown below until there are no more bubbles in the fluid for each wheel.

Tighten the bleeder screw.

Bleed screw tightening torque:

17 in : 6.9 — 12.7 N·m (0.7 — 1.3 kgf·m, 5.1 — 9.4 lb·ft)

18 in : 16.7 — 19.6 N·m (1.7 — 2.0 kgf·m, 12.3 — 14.4 lb·ft)

Troubleshooting

Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem.

If necessary, replace these parts.

Active hood actuator assembly

Specifications

Other information:

Kia Stinger CK 2018-2023 Service Manual: Smart Key

Repair procedures Smart Key Smart Key Code Saving 1. Connect the DLC cable of KDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on KDS. 2. Select the vehicle model and then do «Smart .

Kia Stinger CK 2018-2023 Owners Manual: Driver’s and passenger’s front air bag

■ Driver’s front air bag ■ Driver’s knee air bag ■ Passenger’s front air bag Your vehicle is equipped with an Advanced Supplemental Restraint (Air Bag) System and lap/shoulder belts at both the driver and passenger seating position. The indication of the system’s presence are .

Источник

Kia Stinger CK: Owners and Service manuals

Kia Stinger, a five-passenger fastback sports sedan poised to redefine a segment currently populated by European automakers, the Kia Stinger promises to be the highest-performance production vehicle in the company’s history and is backed by Kia Motors’ industry-leading quality and reliability. Unlike any Kia that has come before it, the Stinger really is a dream car for us, and here today in Detroit, that dream is now a reality after years of commitment and hard work from a passionate group of designers, engineers and executives around the world. Power alone only takes you so far. Stinger’s balanced approach to performance enables it to respond to your every command with both refinement and authority. The more demanding the road, the more impressive is Stinger’s ability to inspire you with its exceptionally refined ride and handling. That feeling never gets old, no matter how long your journey.

Kia Stinger CK 2018-2023 Owners Manual

Kia Stinger CK 2018-2023 Service Manual

• General Information
• Maintenance
• Engine Mechanical System
• Engine Electrical System
• Emission Control System
• Engine Control / Fuel System
• Automatic Transmission System
• 4 Wheel Drive (AWD) System
• Driveshaft and axle
• Suspension System
• Steering System
• Restraint
• Brake System
• Body (Interior and Exterior)
• Front Seat Belt
• Body Electrical System
• Windshield Wiper/Washer
• Heating, Ventilation And Air Conditioning

Источник

AutoSoftos.com

• Доллар — 76.50
• Евро — 91.70

KIA Stinger(CK) G 3.3 T-GDI Service Manual

Описание: Рип сервисной документации KIA Stinger GT.

Год выпуска: 2019
Жанр: Сервисный мануал
Формат: PDF
Количество страниц: 1108 файлов
Качество: Издательский макет или текст (eBook)
Язык авто-книги : Английский

Внимание! Нажимая на ссылку «скачать» Вы обязуетесь, после ознакомления, удалить скаченный файл со своего компьютера. Всё содержимое сайта autosoftos.com взято из свободных источников, и также свободно распространяется. Если это Вы являетесь автором данного материала, то, пожалуйста, свяжитесь с нами, для того чтобы обеспечить пользователям, приятную и удобную альтернативу, после ознакомления, покупки качественного «оригинала» непосредственно от издателя. Администрация сайта не несёт никакой ответственности за противоправные действия, и какой либо ущерб, понесённый правообладателями.

0

0

Источник

Kia Stinger: Automatic Transmission System

Features a fail-safe function that prevents dangerous situations in the event of a transmission failure. The vehicle will be driven in limp home mode if the transmission malfunctions. In this mode, the transmission operates at a minimal functionality level (fixed shifting, limited shifting, reverse, neutral), making it possible for the vehicle to reach a service center.

Limp Home Mode : Limited shifting

Mechanical limp home mode : Fixed shifting (failure of mechanical parts, solenoid valves, TCM, CAN communication)

High Pressure Fuel Pump

Repair procedures Removal 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System — «Release Residual Pressure in Fuel Line») .

Specifications

Service data Service data Automatic Transmission Item Specification Transmission model A8LR1-1 Drive type .

Other information:

Kia Stinger CK 2018-2023 Service Manual: Audio Unit

Components and components location Components Connector Pin Information No. Connector A Connector B Connector C Connector D 1 Rear door left speaker (+) ⁻ ⁻ .

Kia Stinger CK 2018-2023 Service Manual: Brake/Clutch Fluid

Repair procedures Inspection Check the brake fluid level in the brake fluid reservoir. The level should be between “MIN” and “MAX” marks on the side of the reservoir. Use only hydraulic brake fluid conforming to DOT 3 or DOT 4 specification. Check the brake system fo .

Источник